Firemaster Non-structural Gloves
A wristlet cuffed leather glove designed for the hazards faced during non-structural fires, rescues, extrications and site clearances, EN388 certified.
Designed for the unique hazards faced during non-structural rescues, extrications and site clearances, the Non-Structural glove has our unique ergonomic curved finger design paired with a hard-wearing combination of PYROHIDE and Kevlar®. Over the top of the leather at the roll tip fingers and around the palm and thumb, a FR coated Kevlar® material has been added which provides enhanced abrasion and cut resistance. A snug fitting knitted acrylic cuff completes the exterior. The glove has a revolutionary seamless knitted lining of Kevlar® with glass-fibre offering the highest level of cut resistance currently available on the market as well as active perspiration technology through the Viloft plating on the face of this lining yarn. The glove is certified to EN420 and EN388.
OUTER PALM: 100% PYROHIDE cowhide grain leather
LINING: 100% Kevlar® with glass-fibre
CUFF: 100% acrylic
THREAD: 100% cotton
Usually one hand will be slightly larger than the other, typically the dominant hand (the right hand if you are right handed). Using a tape measure, wrap the tape around the dominant hand at the widest part (between your thumb and index finger) and make a loose fist. Make a note of this measurement and check our sizing guide below.
- SIZE XXS = 6"(15.2 cms)
- SIZE XS = 7" (17.8 cms)
- SIZE S = 8" (20.3 cms)
- SIZE M = 9" (22.9 cms)
- SIZE L = 10" (25.4 cms)
- SIZE XL = 11" (27.9 cms)
- SIZE XXL = 12" (30.5 cms)
- SIZE XXXL = 13" (33.0 cms)