Firemaster Debris Gloves

As low as £35.00
In stock

A general purpose, EN388 and elements of EN407 certified great value protective glove used in site clearances when protection from heat and sharps is essential

Our general purpose, great value protective glove. The Debris Glove is widely used in site clearances when protection from heat and sharps is paramout. Made in a gunn cut pattern with a PYROHIDE leather palm and re-inforcement patches on the fingers and across the back of the knuckles, it has a hard wearing cotton fabric back. A knitted acrylic cuff completes the exterior and prevents debris from falling down inside the garment. The glove has a seamless knitted glove within a glove lining of Kevlar® with glass-fibre offering the high levels of cut resistance as well as active perspiration technology through the Viloft plating on the face of this lining yarn. The glove is certified to EN388 and elements of EN407.

OUTER PALM: 100% PYROHIDE cowhide grain leather
OUTER BACK: 100% cotton
LINING: 100% Kevlar® with glass-fibre
CUFF: 100% acrylic
THREAD: 100% cotton

Usually one hand will be slightly larger than the other, typically the dominant hand (the right hand if you are right handed). Using a tape measure, wrap the tape around the dominant hand at the widest part (between your thumb and index finger) and make a loose fist. Make a note of this measurement and check our sizing guide below.

  • SIZE XS = 7" (17.8 cms)
  • SIZE S = 8" (20.3 cms)
  • SIZE M = 9" (22.9 cms)
  • SIZE L = 10" (25.4 cms)
  • SIZE XL = 11" (27.9 cms)
  • SIZE XXL = 12" (30.5 cms)
More Information
Choose Colour Lime
Write Your Own Review
You're reviewing:Firemaster Debris Gloves
Visa Logo
PayPal Logo
Maestro Logo
Mastercard Logo
Braintree Logo
© 2024 Southcombe Gloves Company Number 372391 VAT Number GB 186 2830 43